|
|
Automatic Antenna Tuner
Šváb, Jaroslav ; Lukeš, Zbyněk (referee) ; Šebesta, Jiří (advisor)
This degree work deals with the design and implementation of an automatic antenna tuner for short-wave transmitters. The device works within the short-wave range in (1.5 MHz - 30 MHz) band according to the selection of the given frequency. Its principle is that the tuner has a small range of adapted impedances, but it is usually sufficient for fine tuning of most deviations in the system of antenna 50 - feeder 50 - transceiver outlet 50 . It is also equipped with memories which the settings for the individual bands or frequency segments are stored into. Then the transition from one band to another is quick, easy and, first of all, safe, which is a great advantage. In automatic mode, a SWR limit from which the tuner should start to tune can be set. Interconnection with a TRX is not necessary in a fully automatic mode, the device tunes automatically after keying if the set limit of SWR has been exceeded. The automatic tuning is very quick with this device, if the antenna being tuned is not stored in the memory the tuning lasts ca 0.5 - 6 s, if the tuner uses the memory. It could be said that the work with the tuner is without problems, it is possible to learn to control it in a short time. The tuner is small and light. The result of the whole project is a compact device controlled by the user by means of push buttons.
|
|
|
Automatic antenna analyser
Dufek, Ivo ; Šebesta, Jan (referee) ; Lukeš, Zbyněk (advisor)
This project is dealing with methods of measuring impedances of the antenna systems in the frequency range from the low frequencies to the very high frequencies. There is a discussion about different methods of measuring impedance and each technique is critically evaluated. In terms of this project is compared few types of the professional antenna analyzers. According to this comparison there was made the concept of my own antenna analyzer. There is a detailed description of the design of this device’s important parts including software equipment. Designed instrument has been built and tested.
|
|
|
Magnetic loop antenna with electronic tuning for frequencies below 30MHz
Burda, Miroslav ; Láčík, Jaroslav (referee) ; Urbanec, Tomáš (advisor)
This project deals with electronic tuning and automated adjustment of magnetic loop antennas, working in the High Frequencys. The whole work is divided into three parts tuning, adjustment and control). The tuning part is realized by changing the capacity of the array capacitors and adjustment is done by different changes of power points. The whole system is controlled by a microprocessor ATmega16. According to utility switches the microprocessor capacity, which tunes the antenna to the required frequency, processes information about power adjustment and fine-tuning the antenna by changing the position of charging.
|
|
|
Magnetic loop antenna with electronic tuning for frequencies below 30MHz
Burda, Miroslav ; Vágner, Petr (referee) ; Urbanec, Tomáš (advisor)
This project deals with electronic tuning and automated adjustment of magnetic loop antennas, working in the High Frequencys. The whole work is divided into three parts tuning, adjustment and control). The tuning part is realized by changing the capacity of the array capacitors and adjustment is done by different changes of power points. The whole system is controlled by a microprocessor ATmega16. According to utility switches the microprocessor capacity, which tunes the antenna to the required frequency, processes information about power adjustment and autimatically fine-tuning the antenna by changing the position of charging.
|
|
|
Magnetic Loop Antenna with Electronic Tuning for Frequencies below 30MHz
Svoboda, Luděk ; Vágner, Petr (referee) ; Urbanec, Tomáš (advisor)
The aim of this bachelor's project was realization of a tuning system with complete software and testing of the system's functionality and parameters of antenna. The system is divided into two parts, tuner and controller. The tuner implements change of circuit capacity by switching capacitor series. For switching is used transistor with small transitional capacity but small maximal collector current, too. This parameter restricts the use of system. The second part, controller, uses microcontroller AT89C2051. The microcontroller switches capacitors (and thus sets frequency) according to requests sent from PC with control software. The functionality was checked by tests with network analyzer.
|
|
|
SWR and HF power monitor
Gajdušek, Miroslav ; Blansko), (Metra (referee) ; Šebesta, Jiří (advisor)
This work deals with analysis methods continuous measuring systems for measurement standing wave ratio and high frequency power. Reflectometr, provision measuring standing wawe ratio, works in range frequence VHF (145 MHz, 443 MHz), for this width working frequence is used construction reflectometer with directive lead. Measurer HF power works into range 1kW. Further is in work go through problems communications bus for transmission data from unit monitor SWR a HF power into score modulus. With regard to high frequency interference is choice serial communication RS-485 , which is immune against disturbance. Further is designed evaluation unit MASTER, unit SLAVE and modules for measurement power and SWR. In finish is build up the firmware for units.
|
|
|
Automatic Antenna Tuner
Šváb, Jaroslav ; Lukeš, Zbyněk (referee) ; Šebesta, Jiří (advisor)
This degree work deals with the design and implementation of an automatic antenna tuner for short-wave transmitters. The device works within the short-wave range in (1.5 MHz - 30 MHz) band according to the selection of the given frequency. Its principle is that the tuner has a small range of adapted impedances, but it is usually sufficient for fine tuning of most deviations in the system of antenna 50 - feeder 50 - transceiver outlet 50 . It is also equipped with memories which the settings for the individual bands or frequency segments are stored into. Then the transition from one band to another is quick, easy and, first of all, safe, which is a great advantage. In automatic mode, a SWR limit from which the tuner should start to tune can be set. Interconnection with a TRX is not necessary in a fully automatic mode, the device tunes automatically after keying if the set limit of SWR has been exceeded. The automatic tuning is very quick with this device, if the antenna being tuned is not stored in the memory the tuning lasts ca 0.5 - 6 s, if the tuner uses the memory. It could be said that the work with the tuner is without problems, it is possible to learn to control it in a short time. The tuner is small and light. The result of the whole project is a compact device controlled by the user by means of push buttons.
|
|
|
Magnetic loop antenna with electronic tuning for frequencies below 30MHz
Burda, Miroslav ; Vágner, Petr (referee) ; Urbanec, Tomáš (advisor)
This project deals with electronic tuning and automated adjustment of magnetic loop antennas, working in the High Frequencys. The whole work is divided into three parts tuning, adjustment and control). The tuning part is realized by changing the capacity of the array capacitors and adjustment is done by different changes of power points. The whole system is controlled by a microprocessor ATmega16. According to utility switches the microprocessor capacity, which tunes the antenna to the required frequency, processes information about power adjustment and autimatically fine-tuning the antenna by changing the position of charging.
|
|
|
Magnetic loop antenna with electronic tuning for frequencies below 30MHz
Burda, Miroslav ; Láčík, Jaroslav (referee) ; Urbanec, Tomáš (advisor)
This project deals with electronic tuning and automated adjustment of magnetic loop antennas, working in the High Frequencys. The whole work is divided into three parts tuning, adjustment and control). The tuning part is realized by changing the capacity of the array capacitors and adjustment is done by different changes of power points. The whole system is controlled by a microprocessor ATmega16. According to utility switches the microprocessor capacity, which tunes the antenna to the required frequency, processes information about power adjustment and fine-tuning the antenna by changing the position of charging.
|
|
|
Magnetic Loop Antenna with Electronic Tuning for Frequencies below 30MHz
Svoboda, Luděk ; Vágner, Petr (referee) ; Urbanec, Tomáš (advisor)
The aim of this bachelor's project was realization of a tuning system with complete software and testing of the system's functionality and parameters of antenna. The system is divided into two parts, tuner and controller. The tuner implements change of circuit capacity by switching capacitor series. For switching is used transistor with small transitional capacity but small maximal collector current, too. This parameter restricts the use of system. The second part, controller, uses microcontroller AT89C2051. The microcontroller switches capacitors (and thus sets frequency) according to requests sent from PC with control software. The functionality was checked by tests with network analyzer.
|
guest ::
